This is moar ShootieDoods!!!™, this time with the thing where you can hear me breathing and mumbling about being kiltallinnaspawnzyo.
Yip.
...
https://www.youtube.com/watch?v=ZU4WqTWdeS0
Robitz... another job I had for a bit. We built automated laser-radar metrology QA cells for auto / aero. It was interesting until I learned it all and didn't see any way to re-use it for non-affluent purposes. That and I'm not a fan of traveling to wage-slave colonies and being a part of the same nonsense I'm trying to make redundant / obsolete.
...
https://www.youtube.com/watch?v=skY0jEE7mqU
Recorded via OBS (1080p 6000kbps) through an EasyCap analog video USB2.0 capture device from the video output jack on the following FPV goggle rig;
Fat Shark Dominator HDO
ImmersionRC rapidFIRE VRX Module (v1.2.4 firmware)
Trying to get the best downlink video recording, while flying the terrible Emax TinyHawk camera. I tested all the possible deinterlacing methods, and Yadif 30fps seemed to be the best. 720x480p, 29.97fps NTSC
Definitely less static w/ the rapidFIRE module. Next I'll try with a better cam / vtx.
...
https://www.youtube.com/watch?v=CQZ8c0go5hQ
Repairs: https://youtu.be/wW24R1h9qfI
Day 2: https://youtu.be/yCAfAEo-GqM
Rush-built some new old stock parts into a junker to bash for the weekend. Unfortunately the OSD was on a F1's serial1, which made adjusting the looptime and tune impossible as I didn't bring an iron. I flew the best I could with stock Beta tune and obnoxious-level obese AUW 750g, and still had fun. My crap FPV cam was so lowrez and washed out from the sun that I couldn't see the vibes and oscillations in the goggles anyway. The slo-mo crash at the end of this is when the port bow arm snapped due to the terrible design of the frame arms.
Detroit Multirotor Pitbull (old-ass heavy frame)
Cobra 2204 2300KV Motors
Rotorgeeks RG20 ESC's running BLHeli (OneShot125)
Naze32 Rev6 FC running BetaFlight 3x
DAL "Indestructible" 5040 & 45BN props
...
https://www.youtube.com/watch?v=YhQmUxir5gY
The board mask was covering a bit more copper "+" pad, with vias... so I sand-papered it off and used 22awg... and welders to fix it without a total rebuild (I direct-soldered the motor wires; would've been grr). I screwed around with tuning... anyone get flutter with Kabab's suggested tune from the build guide?
I gotta pack the lab up, more later.
...
https://www.youtube.com/watch?v=QuiXkxDFljU