This is how auto project geometry behaviors in Fusion.
I have this turned off.
0:00 Intro
0:26 Sketch with ghost profile (auto projection)
1:12 Turn off Auto project geometry
1:32 Sketch with no auto projection
1:51 Manual projection if needed
...
https://www.youtube.com/watch?v=bQzryQLa3CA
A little challenge, I hope you like :)
Drawing: https://imgur.com/gallery/nE5JBDI
3D model: https://a360.co/3yw0Ycb
Reddit post: https://www.reddit.com/r/Fusion360/comments/och47l/my_fusion_360_challenge_for_the_month_of_july/
Facebook post: https://www.facebook.com/photo?fbid=4115801551841395&set=gm.4139054102849738
...
https://www.youtube.com/watch?v=2urq8rdlNxQ
Here are some tips and shortcuts I use to make my Fusion 360 experience as smooth as possible.
Time stamps:
0:40 S (Search)
1:40 [Ctrl] -Z (Undo)
2:50 Preferences:
Allow 3D sketching OFF
Auto hide sketch OFF
Scale on first dimension ON
5:30 Short cuts in Sketch:
C (Circle)
L (Line)
Hold - [Ctrl] (No constrains)
D (Dimension)
9:30 E (Extrude Solid)
10:30 Hold mouse button to select profile or plane
13:15 Change dimension in sketch with out editing the sketch
14:15 [F6] Recenter the model/sketch.
...
https://www.youtube.com/watch?v=nsOM5Hrc7No
Here is an answer to a Reddit question about how to move 2 holes 2mm on a bow handle.
0:00 Intro
0:25 Inspecting Mesh
2:36 Mesh Section sketches
3:58 Extracting information from sketches
7:30 Sketch new holes position
10:35 Fill the old holes
11:08 Extrude tool bodies
12:00 Tesselate and combine Mesh
12:33 Wait for Fusion
13:30 Check mesh
14:15 New holes Extrude tool bodies
15:48 Tesselate and combine Mesh
16:18 Fusion "Dark mode" do NOT panic for 2 minutes
18:20 Check final mesh
19:10 Save Mesh and Check in Slicer (Prusa)
...
https://www.youtube.com/watch?v=INqA6TPYwO4
Here is a small weekend challenge.
Try out some workflows and I'll post my workflow on Sunday evening.
You can post the volume of your model if you want to compare, but different workflows will give slightly different volumes.
0:00 Intro
0:10 3D model
0:34 Drawing and Dimensions
...
https://www.youtube.com/watch?v=HJoa7i6BdwU
Link to the circuit: http://www.555-timer-circuits.com/up-down-fading-led.html
Music (Intro):
Deliberate Thought av Kevin MacLeod licensieras under licensen Creative Commons Attribution (https://creativecommons.org/licenses/by/4.0/)
Källa: http://incompetech.com/music/royalty-free/?keywords=deliberate+thought
Artist: http://incompetech.com/
Fading LED, diy, 555 timer, electronic
...
https://www.youtube.com/watch?v=KddaS9V4kao