A simple translational robotic arm that I built that emulates the user's input in real-time, similar to a Hot Cell arm or ROV robotic arm. The microcontroller is a PIC18F27Q10, and the servos are 3 x 10kg (waist, wrist, gripper) servos, and 3 25kg (shoulder, 2 elbows) servos. Powered by 2 18650 cells. Printed in PLA ... https://www.youtube.com/watch?v=rRkXkwGUpIM
Simple 555 fed through npn-pnp transistor driver driving a 1000v 50A MOSFET running at about 175v at about 0.5A.
Please be safe if recreating this setup. I (zker666) am not responsible for any electrocution, burns, or potential death as a result of mishandling the high voltage/high energy apparatuses shown in this video and/or recreating the shown setup without the proper safety/knowledge accompanied with high voltage tinkering. This video is ONLY intended for entertainment and educational purposes that are aimed towards enthusiasts and engineers who are interested in high voltage engineering design and hobby projects that are carried out in a safe and controlled manner.
...
https://www.youtube.com/watch?v=DUdpGa-d9q0
My first attempt and lash up of a simple class e sstc based on Steve ward's design with slight modifications. Mosfet is irfp250, Mosfet driver is UCC37322. 75v then 150v.
...
https://www.youtube.com/watch?v=3kzEFmc7Lu0
Two rewound MOTs each with 3 turns of #2 gauge insulated wire. Primaries wired in parallel, secondaries in series, melting through a 4" 1/8" steel rod
...
https://www.youtube.com/watch?v=h9agqsg6BeY
Running the sstc off 175v dc smoothed with 3200 uF of capacitance for some nice, thick, hot, juicy discharges. Sounds lovely.
...
https://www.youtube.com/watch?v=u4_cKHSyrYg
A crystal radio receiver and amplifier circuit i built using an LM324 to amplify the signal. Next is the radio transmitter!
...
https://www.youtube.com/watch?v=1znIpWX_i58