After a few blunders, I ran out of good negatives, so I will try again on another scrap of aluminum or other metal when I get more printed (as I do not have a laser printer at home). I'm getting closer to a nice dark transfer with each attempt though.
-
WizardsOf12 on Deviantart: https://wizardsof12.deviantart.com/
The music channel: https://www.youtube.com/channel/UCbnPkyuHMycg_VsEAg7ACwQ Instagram: https://www.instagram.com/wizardsof12/
...
https://www.youtube.com/watch?v=yAjwcGrPeAQ
Making noise with a small relay. Capacitors are 0.6uf, 4.7, 6.8, and 47. Instagram: https://www.instagram.com/wizardsof12/
...
https://www.youtube.com/watch?v=nQrrQxtuUrY
Original Song written by the Beatles.
-
Visit my website: https://www.meercreate.com/
Discord: Meercreate(hash)2924
WizardsOf12 on Deviantart: https://wizardsof12.deviantart.com/
WizardsOf12 M: https://www.youtube.com/channel/UCbnPkyuHMycg_VsEAg7ACwQ
...
https://www.youtube.com/watch?v=4dDXGQsFIPo
I built an interesting little tenor guitar out of some aluminum bar stock, some sheet, and some rods, as well as various other parts, including an off the shelf neck that I refretted (Was a very educational experience learning how to dress frets). There was much frustration in getting the fluxless brazing alloy to stick, but eventually, after much cleaning, it will.
Visit my website: https://www.meercreate.com/
Discord: Meercreate(hash)2924
WizardsOf12 on Deviantart: https://wizardsof12.deviantart.com/
WizardsOf12 M: https://www.youtube.com/channel/UCbnPkyuHMycg_VsEAg7ACwQ
...
https://www.youtube.com/watch?v=zIE5Nzd3b2c
Programmed with usbasp. Runs off of internal 8mhz clock. Powered off of vcc of usbasp. Instagram: https://www.instagram.com/wizardsof12/
...
https://www.youtube.com/watch?v=h9iCBVvcb7U
As explained in the previous video ( https://youtu.be/JvRvon3f1sA ), I installed an MGB micro pup (single coil), wrapped in copper foil soldered to the shield for noise reduction, inside a snazzy fabric strap that goes around the body. In essence, this is a strap-on pickup.
I did this due to how hard magnetic pickups are to find in the US or available for export from japan for the taishokoto. I did not want to cut holes in the body, so this is my solution.
It sounds quite nice
-
Discord: Meercreate(hash)2924
Instagram: https://www.instagram.com/meercreate/
WizardsOf12 on Deviantart: https://wizardsof12.deviantart.com/
WizardsOf12 M: https://www.youtube.com/channel/UCbnPkyuHMycg_VsEAg7ACwQ
...
https://www.youtube.com/watch?v=cjmu1UMTVfc