Time to clean out some junk :D

one of the contacts on the relay was melted away to nothing!, makes me wonder what the output stage is like :( the output stage has good readings, 60V across the board for supply to each FET, all the relay does is switch to the speakers, if it can melt a silver contact it can blow the cones out of my speakers :D

Lots going on this weekend! Cleanup Project work Help Brad move huge V8 Play with huge V8 :D

A little bit of mill work on the old King Rich mill. you can see a test piece I made earlier sitting on the vise on the left. Material is 304 Stainless, 38.1mm Dia. Endmill is 12mm solid carbide, was kinda trashed before I even picked it up, but it made it through the job. I was making a crude 24X24 square drive dog for a pool cover roller, accurate finish is optional but I still came in with .05mm deviance across the flats. not bad for an old Taiwan mill, a chipped carbide endmill and somebody like me who never went to trade school, but was taught by a lot of skilled shop hands and machinists.