In this video, we look at the simplest topology used for ac to dc power conversion: the half-wave rectifier with a resistive load. Once we establish the operating principles of the circuit, we consider a more complex case with an inductive load. 0:00 - Introduction 1:28 - Topology and Waveforms 6:06 - Average Output Voltage 8:25 - Half-wave Rectifier w/ Inductive Load 9:22 - Waveforms and discussion ... https://www.youtube.com/watch?v=qvdS-Q8YNgs

In this video we take a brief look at the concept of current division between parallel resistances. ... https://www.youtube.com/watch?v=HYClrxVSTWQ

In this video, we use the canonical switching cell to derive the Buck Converter topology. Then, voltage and current conversion ratios of the converter are developed through analysis of the converter. If you're not familiar with the canonical switching cell, we develop the concept from scratch in: https://youtu.be/YZ08sTPdJ28 NOTE: I made a mistake in drawing the waveforms of the switches around 17:40. The waveforms should be drawn as in these figures: https://bit.ly/3DYUZzQ I sincerely apologize for any inconvenience. Outline: 0:00 Switching States 7:00 Conversion Ratios 15:30 Practical Switch Implementation ... https://www.youtube.com/watch?v=LHrmXI3IiLQ

In this video we look at using the Smith Chart to match the impedance of an antenna to that of a transmission line using a parallel shorted stub. ... https://www.youtube.com/watch?v=KKCkkSrvcqM