These videos are for anyone looking for looking for help with this machine specific CAM software system.
...
https://www.youtube.com/watch?v=UvRN5n0JQhc
A short look at the Blender user interface. Just enough to get everyone moving forward onto basic modeling.
...
https://www.youtube.com/watch?v=Tawq0KQHlwU
This is a fairly old video I had laying around. Sorry for the lack of commentary. Also I normally I don't like just drop music over the top but it felt better than dead air.
Some of the key point here are getting the resin jammed deep into the delammed area and clamping well. Protect the board thoroughly because resin goes everywhere, and have some good tools to sand away the excess when dried.
...
https://www.youtube.com/watch?v=QIbehVWyJwA
This is a short and sweet look at the Shaft and Groove tools without as much detail and conversation as in the full training area.
...
https://www.youtube.com/watch?v=ejwS49eU4QU